Netgear Nighthawk WiFi router is one of the most-used networking devices to get WiFi everywhere in the home or workplace. However, to make the most of the Netgear router, one needs to set it up in a proper way. Below are the basic steps to perform a successful Nighthawk router setup.
Before You Get Started With the Setup
Let’s have a quick glance at the things you need to take care of:
1. Check Your Internet Connection
In case you don’t have a good internet connection, the router setup experience will be maddening. The easiest way is to connect your device to the modem or gateway provided by your Internet Service Provider or ISP. Once your device detects an internet connection, you are all set to install your WiFi router.
2. Gather Information
It is an obvious step but an important one that will save you from frustration when you are in the middle of Netgear WiFi router setup. Make notes including the important setup information such as the default Nighthawk router login details.
3. Check for an App
Netgear offers you both a web dashboard and the Nighthawk app that you can use for both setup and management. With the Netgear Nighthawk app, you don’t need to use a computer to configure the router.
4. Install and Connect Antennas
In the event that your Netgear router comes with antennas, you need to install them before getting started with the Netgear wireless router setup process.
Netgear WiFi Router Setup Steps
Step-1: Decide Where to Place Your Router
The best place for your Netgear WiFi router is an open area because you will benefit from even coverage. But at times, it is not easy to find a location in the open as you have to connect your router to the modem. So, keep the Netgear router in an open area as well as closer to the existing modem.
Step-2: Connect the Modem to Your Router
For this step, you will need an Ethernet cable. Insert one end of the Ethernet cable into the modem whereas another end into the Netgear wireless router. After that, put the modem on power and let it boot up. Also, plug your Netgear router into an electrical outlet and turn it on.
Step-3: Use Web Dashboard or App
In order to continue with the Netgear router setup, there is a need to access the web dashboard or download the Nighthawk mobile app. To access the web-based dashboard, connect your computer to a WiFi network and visit www.routerlogin.net via a web browser. If you are unable to access the default web page, reboot your Nighthawk device as the router troubleshooting measure.
Step-4: Enter the Router Login Details
Whether you are using the Nighthawk app or the web dashboard for setup, the next step requires you to enter the default username and passphrase. Once done, click on the Log In button.
Step-5: Set up Your Router
After logging in, you will land on the Netgear genie smart setup wizard. This wizard will provide you on-screen instructions to install your Netgear wireless router. The same goes for the Nighthawk app. The app will walk you through the setup steps as soon as you logged into your router.
That’s how you can set up and install your Netgear WiFi router. Still having queries? Feel free to drop them down in the comments section.